Knowledge Base


ioStation 24c : Using your ioStation as a DAW Controller with Pro Tools

Published June 23 2021 


PLEASE NOTE:  Please ensure that you have downloaded & installed Universal Control onto your computer.


By default, the ioStation 24c is in Studio One operation mode. To switch to Pro Tools operation, press and hold the NEXT button while powering on your ioStation 24c, then press the Touch button to enable Pro Tools (HUI) operation.


Open Universal Control and check to see if there are any firmware updates for your ioStation 24c. You may need to select Settings>Rescan Network to see the update.



Once you have connected your ioStation 24c to your computer, launch Pro sTools to set up the ioStation 24c as a HUI device.


1. Go to Setups | Peripherals.



2. Create one HUI device under MIDI Controllers.



3. Set the Receive From and Send To menus to “ioStation 24c” and #Ch’s to 8.Screenshot_2021-06-23_at_14.23.43.png


Click “OK.” Your ioStation 24c is now ready to use. Enjoy!



Please contact PreSonus Technical Support by creating a Support Ticket at for further assistance.

>How to create a support ticket<



Was this article helpful?
0 out of 0 found this helpful
Powered by Zendesk