Knowledge Base


ioStation 24c : Using your ioStation as a DAW Controller with Studio One

Published June 17, 2021 


PLEASE NOTE:  Please ensure that you have downloaded & installed Universal Control onto your computer.


Step 1:  If you have changed the ioStation 24c’s Operation Mode and would like to return to using it with Studio One, press and hold the NEXT button while powering on, then press the Solo button to enable Studio One.





Step 2:  Open Universal Control and check to see if there are any firmware updates for your ioStation 24c. You may need to select Settings>Rescan Network to see the update.







Step 3:  Next open Studio One and select New Song.






Step 4:  Then select the Interfaces tab, ioStation 24c and then ok.  





PLEASE NOTE:  The motorized fader on your ioStation 24c should spring into action signaling you are then ready to record/mix/create audio.


Step 5:  If you are unable to control Studio One via the ioStation 24c then go to Studio One>Options on PC or Studio One>Preferences on Mac and select the External Devices tab. 




Step 6:  Highlight the ioStation 24c and select Edit (If you are unable to view the above then click ADD... and select the ioStation 24c from the list)



Step 7:  Ensure that Receive From and Send to are both set as ioStation 24c from their respective dropdown menus.




Your ioStation 24c is now ready to use.





Please contact PreSonus Technical Support by creating a Support Ticket at for further assistance.

>How to create a support ticket<



Was this article helpful?
1 out of 2 found this helpful
Powered by Zendesk