Knowledge Base

Follow

Can I route my FX channels to my Aux outputs on my StudioLive 16.4.2 "Classic" Console?

Reviewed 11/4/2020

 

If you are on firmware version 1.50a +: You can control the send level of the FX channels  by using Aux Flip mode.  To use this mode, select the Aux you want to use and press  the Mix button twice which will switch the first six meters and encoders to become the aux-send level controls for the :

1) Main FireWire Return

2) Analog Tape In

3) Aux Input A

4) Aux Input B

5) FXA 

6) FXB

Aux_Flip_Mode.png

 

While in this mode, the Mix button will remain illuminated, and LEDs at the top, middle, and bottom of meters 7-16 will also illuminate.  Turn the Fat Channel encoders for FX A (5) or FX B (6) and you will see the green LED meter go up, which represents the amount of  level being sent to the Aux.

See section 4.4.3 Aux and FX Bus Channel Sends, the section on Aux Flip Mode, pg 45 in the latest StudioLive Hardware manual:

http://support.presonus.com/attachments/token/qdumxdmhuvbk9nf/?name=StudioLive2442-1642_OwnersManual_EN2.pdf

 

If you are on a firmware version lower than 1.50a:  Go to page 4 of the FX menu of the Studio Live, you can directly patch FX A/B to the desired Aux output. 

 

==================================================================

 

Please contact PreSonus Technical Support by creating a Support Ticket at My.PreSonus.com/Support for further assistance.

>How to create a support ticket<

Was this article helpful?
21 out of 21 found this helpful
Powered by Zendesk