Knowledge Base

Follow

StudioLive Series III - AVB-D16 - AVB General Setup with the StudioLive

Created 11/17/2020

Before proceeding, please be sure your firmware is updated on your StudioLive:

StudioLive Series III Console - Firmware Update

StudioLive Series III Rack mixer - Firmware Update

====================================

 

First, press [Home] on the StudioLive using 2.4+ firmware (released 11/17/20).

Then, choose the "Audio Routing" menu.

StudioLive_64S_17.11.2020_13_28_50.bmp

 

Previously named "Stagebox Setup", choose the "Remote I/O Setup" section to arrange AVB I/O.

StudioLive_64S_17.11.2020_13_28_55.bmp

 

Select the "AVB-D 16" from the list of available AVB Devices.

Then, assign the Outputs FROM the StudioLive (AVB) of your choice tp the AVB-D 16.

StudioLive_64S_17.11.2020_13_29_04.bmp

 

Choose the AVB Sends you wish to Send to DANTE (StudioLive Channels 1-16 being sent in the Screenshot below)

Then press "Apply" to send AVB Sends to the AVB-D 16.

Your DANTE network will now receive these 16 Channels through the AVB-D 16.

(NOTE: You will need to route I/O from Dante Controller)

StudioLive_64S_17.11.2020_13_29_14.bmp

 

 

Return DANTE Channels from the AVB-D 16 to the Channels on the StudioLive of your choice,

Then set those Channels to [Network] input-type.

*In our example here, we are sending the StudioLive's channels 1-16 TO the AVB-D 16 and returning 16 DANTE sourced channels FROM the AVB-D 16 to the StudioLive's inputs 17-32. (See screenshot below)*

StudioLive_64S_17.11.2020_13_29_29.bmp

 

====================================================================

 

Please contact PreSonus Technical Support by creating a Support Ticket at My.PreSonus.com/Support for further assistance.

>How to create a support ticket<

 

Was this article helpful?
0 out of 0 found this helpful
Powered by Zendesk