Knowledge Base

Follow

How to set up ATOM SQ as a MCU device in Logic:

ATOM SQ’s song menu and transport controls can be used to control select features within Logic. This is done by setting up ATOM SQ as a Mackie Control Universal within Logic’s Studio Setup menu. To do this, follow the steps below:

    • Ensure that ATOM SQ is connected to your computer via the USB cable
    • Ensure that Logic’s Advanced Tools are enabled
      • Click Logic Pro from the top task bar
      • Click Preferences 
      • Click Advanced Tools
      • Check the Show Advanced Tools checkbox
    • Click Logic Pro
    • Click Control Surfaces
    • Click Setup
    • Click New in the pop up window
    • Click Install
    • Click Mackie Control from the list of devices
    • Click Add
    • Right Click Mackie Control in the Control Surfaces Setup
    • Click Show/Hide Inspector
    • Select the Input and Output ports to “ATM SQ Control.”
    • Press the Setup button on BEEP’s hardware
    • Press the Page Right button underneath the main encoder
    • Press the button under MCU Mode
    • Press the button above Yes when prompted “Switch to MCU Mode?”
Was this article helpful?
0 out of 0 found this helpful
Powered by Zendesk