Knowledge Base


Automation mode changes in Logic while using FaderPort 8 (MCU mode)

We have found in our testing of the FaderPort 8 (and a number of other controllers using the MCU protocol within Logic) automation modes on selected channels may be subject to unintended changes.

When using your FaderPort 8's "Select" buttons to select channels you may notice the automation mode on the selected channel automatically switches to "Write" automation.

Pressing "Stop" on your controller may also change the selected channel's automation setting to "Touch".

This is due to the implementation of MCU protocols in Logic and not a malfunction of your FaderPort 8.

Was this article helpful?
0 out of 6 found this helpful
Powered by Zendesk