Knowledge Base


FaderPort - How do I set up my FaderPort in Apple Logic/Logic Express?

How do I set up my FaderPort in Apple Logic/Logic Express (Logic 8 and prior)?


Native Mode support for the FaderPort requires installation of the Faderport Control application released on Dec 19, 2017. 

1. Visit the FaderPort download page to get the release and run it to install it. 

2. Run your DAW with FaderPort connected. 

3. Logic Pro / Express should pick up the FaderPort automatically, if not you may need to add it to your list of controllers, see steps below. 


1. Go to Logic > Preferences > Control Surfaces > Setup


2. In the Setup window, go to New > Install



3. Select  PreSonus FaderPort from the list of control surfaces and click “Add”, then close the device list window. 



4. Set the Output Port to “FaderPort and the Input Port to “FaderPort”



This is how the configured Faderport should appear when set up as a native mode controller



Close the Control Surface setup window. Your FaderPort is now ready to use. Enjoy!!

Was this article helpful?
3 out of 7 found this helpful
Have more questions? Submit a request
Powered by Zendesk