Knowledge Base

Follow

FaderPort Classic - How do I set up my FaderPort Classic in Cubase/Nuendo in Native Mode?

This article applies to this model FaderPort:

PreSonus_FaderPort_Classic.png

How do I set up my FaderPort Classic in Cubase/Nuendo in Native Mode?

Native Mode support for the FaderPort Classic requires installation of the Faderport Control application released on Dec 19, 2017. 

1. Visit the FaderPort Classic download page to get the release and run it to install it. 

2. Run your DAW with FaderPort connected. 

---------------------------------------------------------------------- 

1. In Cubase/Nuendo, go to Devics > Device Setup

3-Device_Setup.jpg

2. Click the + symbol to Add Device, and choose the Presonus Faderport. If you don't see the option for Presonus Faderport, see the note at the beginning of this article

4-Add_Device.jpg

3. There should now be a listing under Remote Devices for the Presonus Faderport. Make sure the MIDI Input and Output ports are set to Faderport

5-Faderpot_Device.JPG

4. Additionally, since the Faderport is a control surface and not a MIDI instrument or controller/keyboard, make sure you un-check the Faderport from In All MIDI under the MIDI Port Setup section

6-ALL_MIDI.JPG

 

Your FaderPort Classic should now be ready to use!

Was this article helpful?
4 out of 7 found this helpful
Have more questions? Submit a request
Powered by Zendesk