Knowledge Base

Follow

Can I daisy-chain my FireStudio family interface to my FirePod/FP10?

The FireStudio family interfaces and the FirePod/FP use two different drivers and so cannot be used together on the same system.

 

1) The FP10/Firepod is a device that utilized the BridgeCo chip vs the Dice Chip on the Project - which makes them incompatible
2) The FP10/Firepod out-dates the Project by many years, is discontinued and was replaced with the Project
3) The PF10/Fiepod uses a completely different driver and firmware than the Project, which again makes chaining them together impossible.

If you take a look at page 34 of the manual for the FSProject :

http://www.presonus.com/downloads/products/pdf/FireStudioProject_OwnersManual_EN.pdf

You will see clearly the options for what can be chained to the FSProject.

This article show you how to link multiple FP10/Firepods:

http://www.presonus.com/downloads/products/pdf/multiFPhowtoXP.pdf

Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request
Powered by Zendesk