Knowledge Base

Follow

FireBox - Why won't my S/PDIF input won't register any signal?

Question:

Why won't my S/PDIF input won't register any signal?

 

Answer:

To use the S/PDIF input, your interface will need to be clocked via S/PDIF to the device you're getting input off of. Unplug the S/PDIF input on your interface and open your interface's control panel. Now set your Clock Source to S/PDIF. When the sync light begins flashing, plug your device's S/PDIF output into your interface's S/PDIF input. When the light stops flashing, you should be ready to record the S/PDIF input.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request
Powered by Zendesk