Knowledge Base/Discontinued Products /Legacy Products

Can I daisy-chain my FireStudio family interface to my FirePod/FP10?

Technical Support
posted this on November 09, 2010 03:02 PM

The FireStudio family interfaces and the FirePod/FP use two different drivers and so cannot be used together on the same system.

 

1) The FP10/Firepod is a device that utilized the BridgeCo chip vs the Dice Chip on the Project - which makes them incompatible
2) The FP10/Firepod out-dates the Project by many years, is discontinued and was replaced with the Project
3) The PF10/Fiepod uses a completely different driver and firmware than the Project, which again makes chaining them together impossible.

If you take a look at page 34 of the manual for the FSProject :

http://www.presonus.com/uploads/products/2324/downloads/FireStudioP...

You will see clearly the options for what can be chained to the FSProject.

These articles show you how to link multiple FP10/Firepods:

http://www.presonus.com/uploads/products/1714/downloads/multiFPhowt...
http://www.presonus.com/uploads/products/1714/downloads/multiFPhowt...

 
Topic is closed for comments